Service Infiniti QX4 since 1996 of release
1. Introduction
2. The maintenance instruction
3. Routine maintenance
4. The engine
5. Cooling and heating systems
6. Power supply systems and managements
7. Start and charge systems
8. A transmissionnaja line
9. Brake system
9.1. Specifications
9.2. System of antiblocking of brakes (ABS) - the general information and codes of malfunctions
9.3. Check of a condition and replacement of brake lines and hoses
9.4. Replacement колодок disk brake mechanisms of forward wheels
9.5. Removal and installation of a support of the disk brake mechanism
9.6. Removal and installation of a brake disk
9.7. Replacement of brake boots of drum-type brake mechanisms of back wheels
9.8. Removal and installation of the main brake cylinder (ГТЦ)
9.9. Removal and installation of assemblage of the vacuum amplifier of brakes
9.10. Prorolling of brake system
9.11. Adjustment of a drive of a lay brake
9.12. Adjustments of a pedal of a foot brake
9.13. Adjustment of a spring of the valve-regulator sensitive to loading (LSV)
9.14. Adjustment of gauges-switches of stoplights and темпостата
9.15. Removal and hydromodulator ABS installation
9.16. Removal and G-gauge installation
9.17. Check of serviceability of functioning of wheel gauges ABS
9.18. Check of serviceability of functioning of the G-gauge
9.19. Check of serviceability of functioning of the relay приводного the hydromodulator electromotor
9.20. Check of serviceability of functioning of the relay of the electromagnetic valve of hydraulic modulator ABS
10. A suspension bracket and a steering
11. A body
12. An electric equipment
 












9-9-snyatie-i-ustanovka-sborki-vakuumnogo-usilitelya-tormozov.html

9.9. Removal and installation of assemblage of the vacuum amplifier of brakes

 PERFORMANCE ORDER

  1. Remove ГТЦ (Removal and installation of the main brake cylinder (ГТЦ see)).
  2. In car salon remove a fixing pin and disconnect a rod of a pusher of the amplifier from the lever of a pedal of a foot brake.
  3. Disconnect from assemblage of the brake amplifier a vacuum hose.
  4. Give fixing nuts and remove assemblage of the vacuum amplifier from a back partition of an impellent compartment.
  5. Installation is made upside-down, — before installation ГТЦ make pusher adjustment (see more low).


Adjustment of a rod of a pusher

 PERFORMANCE ORDER

  1. Connect to the reception union of assemblage of the vacuum amplifier the manual vacuum pump and create in assemblage depression by depth of 508 mm  hg Measure size выступания a rod of a pusher from an assemblage casing. The rating value makes 10.1—10.4 mm. If to adjust a rod it is not possible, replace assemblage of the brake amplifier.


On page back
9.8. Removal and installation of the main brake cylinder (ГТЦ)
On the following page
9.10. Prorolling of brake system