Service Infiniti QX4 since 1996 of release
1. Introduction
2. The maintenance instruction
3. Routine maintenance
4. The engine
5. Cooling and heating systems
6. Power supply systems and managements
7. Start and charge systems
8. A transmissionnaja line
9. Brake system
9.1. Specifications
9.2. System of antiblocking of brakes (ABS) - the general information and codes of malfunctions
9.3. Check of a condition and replacement of brake lines and hoses
9.4. Replacement колодок disk brake mechanisms of forward wheels
9.5. Removal and installation of a support of the disk brake mechanism
9.6. Removal and installation of a brake disk
9.7. Replacement of brake boots of drum-type brake mechanisms of back wheels
9.8. Removal and installation of the main brake cylinder (ГТЦ)
9.9. Removal and installation of assemblage of the vacuum amplifier of brakes
9.10. Prorolling of brake system
9.11. Adjustment of a drive of a lay brake
9.12. Adjustments of a pedal of a foot brake
9.13. Adjustment of a spring of the valve-regulator sensitive to loading (LSV)
9.14. Adjustment of gauges-switches of stoplights and темпостата
9.15. Removal and hydromodulator ABS installation
9.16. Removal and G-gauge installation
9.17. Check of serviceability of functioning of wheel gauges ABS
9.18. Check of serviceability of functioning of the G-gauge
9.19. Check of serviceability of functioning of the relay приводного the hydromodulator electromotor
9.20. Check of serviceability of functioning of the relay of the electromagnetic valve of hydraulic modulator ABS
10. A suspension bracket and a steering
11. A body
12. An electric equipment
 






тюнинг автомобилей, персональная студия в киеве.
Купить женское нижнее белье купить.






9-8-snyatie-i-ustanovka-glavnogo-tormoznogo-cilindra-gtc.html

9.8. Removal and installation of the main brake cylinder (ГТЦ)


Design ГТЦ


Removal

 PERFORMANCE ORDER

  1. Disconnect a negative wire from the battery.
  2. Disconnect electroconducting from the gauge-switch of level of a brake liquid.
  3. Remove a plastic cover, by means of a syringe or a rubber pear pump out from tank GTTS as it is possible большее quantity of a brake liquid, then establish a cover into place.
  4. Disconnect from ГТЦ and at once закупорьте brake lines.
  5. Release fixing nuts and remove ГТЦ in gathering with the tank.
  6. In case of need remove from the main cylinder the tank.


Installation

 PERFORMANCE ORDER

  1. Installation is made in an order, the return to an order of dismantle of components, — track reliability of a tightening of fixture. In summary pump over brake system.
  2. Connect to the tank hydraulic lines and electroconducting of the gauge of level of a brake liquid.
  3. The further installation is made as it should be the return to an order of dismantle of components.
  4. In summary fill in in the tank fresh brake liquid DOT 3, pump over a hydraulic path (Prorolling of a hydraulic path of a steering drive see) and execute adjustment of a pedal of a foot brake (Replacement колодок disk brake mechanisms of forward wheels see).


On page back
9.7. Replacement of brake boots of drum-type brake mechanisms of back wheels
On the following page
9.9. Removal and installation of assemblage of the vacuum amplifier of brakes