Service Infiniti QX4 since 1996 of release
1. Introduction
2. The maintenance instruction
3. Routine maintenance
4. The engine
5. Cooling and heating systems
6. Power supply systems and managements
7. Start and charge systems
8. A transmissionnaja line
9. Brake system
9.1. Specifications
9.2. System of antiblocking of brakes (ABS) - the general information and codes of malfunctions
9.3. Check of a condition and replacement of brake lines and hoses
9.4. Replacement колодок disk brake mechanisms of forward wheels
9.5. Removal and installation of a support of the disk brake mechanism
9.6. Removal and installation of a brake disk
9.7. Replacement of brake boots of drum-type brake mechanisms of back wheels
9.8. Removal and installation of the main brake cylinder (ГТЦ)
9.9. Removal and installation of assemblage of the vacuum amplifier of brakes
9.10. Prorolling of brake system
9.11. Adjustment of a drive of a lay brake
9.12. Adjustments of a pedal of a foot brake
9.13. Adjustment of a spring of the valve-regulator sensitive to loading (LSV)
9.14. Adjustment of gauges-switches of stoplights and темпостата
9.15. Removal and hydromodulator ABS installation
9.16. Removal and G-gauge installation
9.17. Check of serviceability of functioning of wheel gauges ABS
9.18. Check of serviceability of functioning of the G-gauge
9.19. Check of serviceability of functioning of the relay приводного the hydromodulator electromotor
9.20. Check of serviceability of functioning of the relay of the electromagnetic valve of hydraulic modulator ABS
10. A suspension bracket and a steering
11. A body
12. An electric equipment
 

9-5-snyatie-i-ustanovka-supporta-diskovogo-tormoznogo-mekhanizma.html

9.5. Removal and installation of a support of the disk brake mechanism

 PERFORMANCE ORDER

  1. Поддомкратьте redock of the car also establish it on props (the Scheme of an institution of props for car fixing in the lifted position see an illustration). Remove a corresponding forward wheel.
  2. Disconnect from a support a brake line, — at once закупорьте the open end of a line for the purpose of minimisation of losses of a brake liquid, and also in order to avoid hit in dirt system.
  3. Turn out fixing bolts (the Design of disk brake mechanisms of forward wheels see an illustration) and remove a support.
  4. Installation is made upside-down, — track, that all fixture has been tightened with demanded effort.
  5. In summary pump over brake system (Prorolling of brake system see).

«On page back
9.4. Replacement колодок disk brake mechanisms of forward wheels		 On the following page»
9.6. Removal and installation of a brake disk