Service Infiniti QX4 since 1996 of release
1. Introduction
2. The maintenance instruction
3. Routine maintenance
4. The engine
5. Cooling and heating systems
6. Power supply systems and managements
7. Start and charge systems
8. A transmissionnaja line
9. Brake system
9.1. Specifications
9.2. System of antiblocking of brakes (ABS) - the general information and codes of malfunctions
9.3. Check of a condition and replacement of brake lines and hoses
9.4. Replacement колодок disk brake mechanisms of forward wheels
9.5. Removal and installation of a support of the disk brake mechanism
9.6. Removal and installation of a brake disk
9.7. Replacement of brake boots of drum-type brake mechanisms of back wheels
9.8. Removal and installation of the main brake cylinder (ГТЦ)
9.9. Removal and installation of assemblage of the vacuum amplifier of brakes
9.10. Prorolling of brake system
9.11. Adjustment of a drive of a lay brake
9.12. Adjustments of a pedal of a foot brake
9.13. Adjustment of a spring of the valve-regulator sensitive to loading (LSV)
9.14. Adjustment of gauges-switches of stoplights and темпостата
9.15. Removal and hydromodulator ABS installation
9.16. Removal and G-gauge installation
9.17. Check of serviceability of functioning of wheel gauges ABS
9.18. Check of serviceability of functioning of the G-gauge
9.19. Check of serviceability of functioning of the relay приводного the hydromodulator electromotor
9.20. Check of serviceability of functioning of the relay of the electromagnetic valve of hydraulic modulator ABS
10. A suspension bracket and a steering
11. A body
12. An electric equipment
 






Обзор: новости россии и мира





9-4-zamena-kolodok-diskovykh-tormoznykh-mekhanizmov-perednikh-koles.html

9.4. Replacement колодок disk brake mechanisms of forward wheels


Design of disk brake mechanisms of forward wheels


Removal

 PERFORMANCE ORDER

  1. Поддомкратьте redock of the car also establish it on props (the Scheme of an institution of props for car fixing in the lifted position see an illustration). Remove a corresponding forward wheel. Turn out the bottom fixing bolt and develop a support upwards on a directing finger.
  2. Remove holders колодок and adjusting linings. Remove колодки and measure a residual thickness of their frictional overlays (the minimum admissible value makes 2.0 mm). In case of need make replacement колодок.


Installation

 PERFORMANCE ORDER

  1. Wipe duster the piston of the wheel cylinder and directing fingers.
  2. Wring out the piston and plant in анкерную скобу internal колодку.
  3. Grease contacting to holders колодок surfaces of a support special brake greasing, then establish external колодку and adjusting linings.
  4. Establish holders колодок.
  5. Lower a support in regular position and establish the bottom fixing bolt.
  6. Tighten bolts with demanded effort, then some times squeeze out a pedal of a foot brake for усадки components of the brake mechanism.


On page back
9.3. Check of a condition and replacement of brake lines and hoses
On the following page
9.5. Removal and installation of a support of the disk brake mechanism