Service Infiniti QX4 since 1996 of release
1. Introduction
2. The maintenance instruction
3. Routine maintenance
4. The engine
5. Cooling and heating systems
6. Power supply systems and managements
7. Start and charge systems
8. A transmissionnaja line
9. Brake system
9.1. Specifications
9.2. System of antiblocking of brakes (ABS) - the general information and codes of malfunctions
9.3. Check of a condition and replacement of brake lines and hoses
9.4. Replacement колодок disk brake mechanisms of forward wheels
9.5. Removal and installation of a support of the disk brake mechanism
9.6. Removal and installation of a brake disk
9.7. Replacement of brake boots of drum-type brake mechanisms of back wheels
9.8. Removal and installation of the main brake cylinder (ГТЦ)
9.9. Removal and installation of assemblage of the vacuum amplifier of brakes
9.10. Prorolling of brake system
9.11. Adjustment of a drive of a lay brake
9.12. Adjustments of a pedal of a foot brake
9.13. Adjustment of a spring of the valve-regulator sensitive to loading (LSV)
9.14. Adjustment of gauges-switches of stoplights and темпостата
9.15. Removal and hydromodulator ABS installation
9.16. Removal and G-gauge installation
9.17. Check of serviceability of functioning of wheel gauges ABS
9.18. Check of serviceability of functioning of the G-gauge
9.19. Check of serviceability of functioning of the relay приводного the hydromodulator electromotor
9.20. Check of serviceability of functioning of the relay of the electromagnetic valve of hydraulic modulator ABS
10. A suspension bracket and a steering
11. A body
12. An electric equipment
 






Урна металлическая

Самая свежая информация урна металлическая у нас.

hozotdel.ru







9-20-proverka-ispravnosti-funkcionirovaniya-rele-ehlektromagnitnogo-klapana-gidravlicheskogo-modulyatora-abs.html

9.20. Check of serviceability of functioning of the relay of the electromagnetic valve of hydraulic modulator ABS

The relay of the electromotor is a part of the block of relay ABS which at negative results of check is subject to replacement in gathering.


 PERFORMANCE ORDER

  1. Disconnect electroconducting from relay ABS block (the arrangement Scheme see the car of elements ABS an illustration).
  2. Check up conductivity presence between the plug № 21 and №№ 3 and 16 blocks of the relay (Check of the block of relay ABS see an illustration). If conductivity is absent in both cases, pass to a following stage of check, otherwise replace the block.
  3. Submit pressure of the battery (12) between plugs №№ 5 and 7 and repeat the previous check. This time conductivity should take place, otherwise the block is subject to replacement.
  4. Remove stress from the block and measure resistance between plugs №№ 5 and 7. The Rating value makes 70.8—157.8 Ohm. The faulty block is subject to replacement.


«On page back
9.19. Check of serviceability of functioning of the relay приводного the hydromodulator electromotor
On the following page»
10. A suspension bracket and a steering