Service Infiniti QX4 since 1996 of release
1. Introduction
2. The maintenance instruction
3. Routine maintenance
4. The engine
5. Cooling and heating systems
6. Power supply systems and managements
7. Start and charge systems
8. A transmissionnaja line
9. Brake system
9.1. Specifications
9.2. System of antiblocking of brakes (ABS) - the general information and codes of malfunctions
9.3. Check of a condition and replacement of brake lines and hoses
9.4. Replacement колодок disk brake mechanisms of forward wheels
9.5. Removal and installation of a support of the disk brake mechanism
9.6. Removal and installation of a brake disk
9.7. Replacement of brake boots of drum-type brake mechanisms of back wheels
9.8. Removal and installation of the main brake cylinder (ГТЦ)
9.9. Removal and installation of assemblage of the vacuum amplifier of brakes
9.10. Prorolling of brake system
9.11. Adjustment of a drive of a lay brake
9.12. Adjustments of a pedal of a foot brake
9.13. Adjustment of a spring of the valve-regulator sensitive to loading (LSV)
9.14. Adjustment of gauges-switches of stoplights and темпостата
9.15. Removal and hydromodulator ABS installation
9.16. Removal and G-gauge installation
9.17. Check of serviceability of functioning of wheel gauges ABS
9.18. Check of serviceability of functioning of the G-gauge
9.19. Check of serviceability of functioning of the relay приводного the hydromodulator electromotor
9.20. Check of serviceability of functioning of the relay of the electromagnetic valve of hydraulic modulator ABS
10. A suspension bracket and a steering
11. A body
12. An electric equipment
 












9-18-proverka-ispravnosti-funkcionirovaniya-g-datchika.html

9.18. Check of serviceability of functioning of the G-gauge

The gauge of accelerations is among the fragile and easily damaged components, the dropped gauge is subject to replacement.


 PERFORMANCE ORDER

  1. Disconnect from the gauge of accelerations electroconducting.
  2. Remove the gauge from the car and lay it on a flat surface.
  3. Measure resistance between plugs №№ 2 and 51 gauges (Check of the block of relay ABS see an illustration), — demanded value makes 1400—1600 Ohm.
  1. Incline the gauge at an angle a minimum 23 , — this time resistance between plugs №№ 2 and 51 should make 4700—5500 Ohm.
  2. Measure resistance between plugs №№ 1 and 17 gauges, — demanded value makes 70—124 Ohm.
  1. At negative results of any of checks replace the gauge.


On page back
9.17. Check of serviceability of functioning of wheel gauges ABS
On the following page
9.19. Check of serviceability of functioning of the relay приводного the hydromodulator electromotor