Service Infiniti QX4 since 1996 of release
1. Introduction
2. The maintenance instruction
3. Routine maintenance
4. The engine
5. Cooling and heating systems
6. Power supply systems and managements
7. Start and charge systems
8. A transmissionnaja line
9. Brake system
9.1. Specifications
9.2. System of antiblocking of brakes (ABS) - the general information and codes of malfunctions
9.3. Check of a condition and replacement of brake lines and hoses
9.4. Replacement колодок disk brake mechanisms of forward wheels
9.5. Removal and installation of a support of the disk brake mechanism
9.6. Removal and installation of a brake disk
9.7. Replacement of brake boots of drum-type brake mechanisms of back wheels
9.8. Removal and installation of the main brake cylinder (ГТЦ)
9.9. Removal and installation of assemblage of the vacuum amplifier of brakes
9.10. Prorolling of brake system
9.11. Adjustment of a drive of a lay brake
9.12. Adjustments of a pedal of a foot brake
9.13. Adjustment of a spring of the valve-regulator sensitive to loading (LSV)
9.14. Adjustment of gauges-switches of stoplights and темпостата
9.15. Removal and hydromodulator ABS installation
9.16. Removal and G-gauge installation
9.17. Check of serviceability of functioning of wheel gauges ABS
9.18. Check of serviceability of functioning of the G-gauge
9.19. Check of serviceability of functioning of the relay приводного the hydromodulator electromotor
9.20. Check of serviceability of functioning of the relay of the electromagnetic valve of hydraulic modulator ABS
10. A suspension bracket and a steering
11. A body
12. An electric equipment
 












9-15-snyatie-i-ustanovka-gidromodulyatora-abs.html

9.15. Removal and hydromodulator ABS installation

 PERFORMANCE ORDER

  1. Disconnect a negative wire from the battery.
  2. Merge a hydraulic liquid from brake lines.
  3. Mark adjusting position of lines and disconnect them from hydromodulator assemblage (the arrangement Scheme see the car of elements ABS an illustration).
  4. Disconnect from the modulator electroconducting.
  5. Give three fixing nuts and remove hydromodulator assemblage.
  6. Without tightening штуцерные sockets connect to the modulator hydraulic lines.
  7. Establish modulator assemblage on the regular place and tighten fixing nuts.
  8. Tighten with demanded effort штуцерные sockets of brake lines.
  9. In summary add in tank GTTS necessary quantity of a hydraulic liquid of a demanded grade and pump over brake system (Prorolling of brake system see).


On page back
9.14. Adjustment of gauges-switches of stoplights and темпостата
On the following page
9.16. Removal and G-gauge installation