Service Infiniti QX4 since 1996 of release
1. Introduction
2. The maintenance instruction
3. Routine maintenance
4. The engine
5. Cooling and heating systems
6. Power supply systems and managements
7. Start and charge systems
8. A transmissionnaja line
8.1. 4-step automatic transmission
8.1.1. The general information
8.1.2. Problem diagnostics АТ - the general information
8.1.3. The Elektronno-hydraulic control system 4-step АТ
8.1.4. Removal and transmission installation
8.1.5. Replacement of an epiploon of lengthening of transmission
8.1.6. Removal and installation of cooler ATF
8.1.7. Removal and installation клапанной assemblages of a hydraulic contour of management АТ
8.1.8. Removal, check of a condition and installation приводного a cable of blocking of switchings
8.1.9. Adjustment of a drive of switching АТ
8.1.10. Adjustment of the gauge-switch of positions АТ / start permissions
8.1.11. Major repairs АТ
8.2. A distributing box
8.3. Differentials, power shafts / semiaxes
8.4. Kardannye shaft
9. Brake system
10. A suspension bracket and a steering
11. A body
12. An electric equipment
 












8-1-6-snyatie-i-ustanovka-okhladitelya-atf.html

8.1.6. Removal and installation of cooler ATF


Details of installation of cooler ATF


The scheme of connection of lines of a path of cooling ATF

 PERFORMANCE ORDER

  1. Remove a decorative lattice of a radiator.
  2. Disconnect from assemblage of cooler ATF hoses.
  3. Release fixture and remove cooler assemblage.
  4. Remove a basic arm of cooler ATF.
  5. Release fixing collars and remove the hoses going from a cooler to a radiator and to transmission (the Scheme of connection of lines of a path of cooling ATF see an illustration).
  6. Turn out bolts of fastening of a basic arm of a tube of a cooler.
  7. Remove a hose in gathering with a basic arm.
  8. Installation is made upside-down, — track, that all fixture has been tightened a support with demanded effort.
  9. In summary check up level ATF, in case of need make corresponding updating (Routine maintenance see the Head).


On page back
8.1.5. Replacement of an epiploon of lengthening of transmission
On the following page
8.1.7. Removal and installation клапанной assemblages of a hydraulic contour of management АТ