12-5-preryvateli-cepi-obshhaya-informaciya.html
12.5. Chain breakers - the general information
Arrangement of two breakers of a chain in салонном the assembly block of safety locks / of the relay
Chain breakers are used for protection of such components of system of an onboard electric equipment, as head headlights and drive electromotors steklopodemnikov/covers of the top hatch / of door-locks, etc. (see an illustration above).
On some models after operation breakers revert to the original state automatically. If causing switching-off of the breaker the overload had not incidental character, it is necessary to check up a condition of a corresponding contour immediately. After elimination of malfunction the chain breaker enters again into a normal mode of functioning. Sometimes return of the breaker to a working condition should be made manually after elimination of the reason of an overload.
For breaker introduction in a working condition disconnect a negative wire from the battery.
|
If the stereosystem established on the car is equipped by a security code before to disconnect the battery make sure that have a correct combination for audiosystem input in action! |
Take the breaker, pass a thin core in specially provided aperture in the case and push it in an aperture before click. Then it makes sense to make sure by means of an ohmmeter available conductivity between plugs of the breaker and only after that to establish it into place.
|