10-12-snyatie-i-ustanovka-komponentov-i-sborki-zadnejj-podveski.html
10.12. Removal and installation of components and assemblage of a back suspension bracket The general design of a back suspension bracket — cм. An illustration the Design of a back suspension bracket.
Details of installation of elements of a back suspension bracket on the car
|
- Before to start to отпусканию fixture of components, prop up assemblage of the back bridge тележечным a jack, having enclosed on its head the wooden block.
- Having hung out a suspension bracket, disconnect from brake boards hydraulic brake lines and cables of a drive of a lay brake.
|
In order to avoid a rounding off шлицов накидных choke nuts use special накидной a key with a cutting head. Remove from a suspension bracket wheel gauges ABS and take them aside together with the connected electroconducting. |
- Release fixture of collars of fastening of a bar of the back stabilizer of cross-section stability to a body.
- Give fixture and disconnect from the car bottom the top and bottom levers of a suspension bracket.
- Disconnect propeller a shaft from the main transfer of the back bridge.
- Give nuts of fastening of the top support of back shock-absorbers.
- In case of need remove from assemblage components requiring replacement.
- Installation is made upside-down.
|
|
|
|
The definitive tightening of fixture of the elements equipped with rubber plugs is made in the unloaded condition with the wheels lowered on the earth. |
|
|
|